Norgren 10A511038 Elbow Banjo Tube Fitting Bspp

Product Description

The NORGREN 10A511038 is a push-to-connect elbow banjo tube fitting designed for general-purpose pneumatic and fluid conveying systems. It features a tube-by-male-by-tube-by-male BSPP connection configuration in an elbow banjo geometry, allowing tube runs to change direction while maintaining a secure, tool-free push-to-connect engagement on the tube ports. The body is nickel-plated brass with a nitrile O-ring seal, rated to 260 psi maximum working pressure. The 3/8-inch BSPP male thread interfaces with standard British Standard Parallel Pipe ported components. Installed by millwrights, pipefitters, and pneumatic system technicians.

This fitting is suited for general-purpose pneumatic and fluid distribution lines in industrial and commercial applications. The banjo elbow configuration is commonly used where a tube line must connect to a ported block, manifold, or valve body at an angle, saving space in tight panel or machine enclosures. The push-to-connect tube ports accept 10 mm outside diameter tubing, making it compatible with standard metric pneumatic tubing used in automation and process control installations.

Key Features

• Push-to-connect tube ports for fast, tool-free tube insertion and release
• Elbow banjo geometry allows angled tube routing at ported connections
• Nickel-plated brass body resists corrosion in industrial environments
• Nitrile O-ring seal provides reliable fluid and air sealing
• Rated to 260 psi maximum working pressure
• 3/8 inch BSPP male thread for compatibility with standard metric-ported components

Compatibility

Designed for general-purpose pneumatic and fluid conveying systems using 10 mm outside diameter push-to-connect tubing with 3/8 inch BSPP ported valves, manifolds, or blocks.

Installation Notes

Shut down and fully depressurize the system before removing or installing any fittings. Ensure the mating BSPP port is clean and undamaged before threading the fitting in by hand, then wrench-tighten to avoid distorting the brass body. Insert tubing fully into the push-to-connect port until it seats; confirm retention by pulling back lightly on the tube before re-pressurizing. Verify the installed assembly is within the rated temperature range before returning the system to service.