Norgren 100291400 Bulkhead Connector Tube Fitting 260 Psi

Product Description

The NORGREN 100291400 is a push-to-connect bulkhead tube fitting designed for tube-to-tube connections in pneumatic and fluid-transfer systems. It accepts 14mm outside-diameter tubing and features an M24x1.5 thread for secure panel or bulkhead mounting. Built from nickel-plated brass, it handles working pressures up to 260 psi and operates across a temperature range of 0 to 175 degrees F. The nitrile O-ring provides a reliable seal in general-purpose compressed air and compatible fluid applications. Licensed plumbers, pipefitters, and pneumatic system technicians are the typical installers.

This fitting suits general-purpose pneumatic and fluid-handling installations where a tube line must pass through a panel, bulkhead, or enclosure wall. The push-to-connect design allows fast, tool-free tube insertion while the M24x1.5 threaded body locks into the mounting surface with a standard nut. At 41.5mm overall length, it fits standard panel cutouts in industrial, HVAC, and light commercial equipment. It is rated for continuous service within its stated pressure and temperature limits.

Key Features

• Push-to-connect design for fast, tool-free tube insertion and removal
• Accepts 14mm outside-diameter tubing
• M24x1.5 threaded body for secure bulkhead panel mounting
• Rated to 260 psi maximum working pressure
• Nickel-plated brass construction for corrosion resistance
• Nitrile O-ring seal compatible with compressed air and general-purpose fluids
• Operating temperature range of 0 to 175 degrees F

Compatibility

Designed for general-purpose pneumatic and fluid-transfer systems requiring a bulkhead tube-to-tube connection with 14mm OD tubing and an M24x1.5 threaded panel mount.

Installation Notes

Installation is typically performed by pipefitters or pneumatic system technicians. Depressurize and isolate the line completely before removing or installing any fitting. Ensure the panel or bulkhead cutout is sized and finished to the fitting manufacturer specifications before threading the body through. Verify tubing is cut square, deburred, and fully seated to the tube stop before pressurizing the system.