Mueller Streamline ABSDBLFIX32 Abs Dwv Double Fixture Tee Hub

Product Description

The MUELLER STREAMLINE ABSDBLFIX32 is an ABS DWV double fixture tee hub fitting designed for drain, waste, and vent piping systems. This four-port fitting connects two fixture drain lines into a common drain stack or horizontal run. The hub-end connections accept standard ABS pipe for solvent-weld assembly. With inlet dimensions of 3 inches by 2 inches by 3 inches by 3 inches, this tee accommodates dual fixture connections while maintaining proper drainage slope and flow direction. Licensed plumbers and drain-waste-vent installers use this fitting in residential and light commercial rough-in work.

This fitting is suited for residential and light commercial DWV rough-in applications where two fixture drain lines must tie into a single stack or horizontal branch line. Typical installations include back-to-back lavatory or sink configurations, wet wall assemblies, and multi-fixture bathroom groupings. The double fixture tee geometry supports proper flow dynamics required by code for simultaneous fixture drainage. It is installed in concealed wall and floor framing before finish surfaces are applied.

Key Features

• ABS construction provides chemical resistance and durability in drain, waste, and vent service
• Hub ends accept standard ABS pipe for solvent-weld connections
• Double fixture configuration allows two fixture drains to tie into one common line
• Four-port geometry with 3 inch by 2 inch by 3 inch by 3 inch sizing covers common residential fixture drain combinations
• Lightweight ABS material simplifies handling and positioning during overhead or wall rough-in

Compatibility

Designed as an OEM-style replacement and new-installation fitting for standard ABS DWV piping systems using solvent-weld hub connections.

Installation Notes

Installation must be performed by a licensed plumber in accordance with the International Plumbing Code or applicable local plumbing code. Shut off water supply and ensure the drain system is clear before beginning work. Use ABS-rated solvent cement and primer where required by local code, and allow full cure time before pressure-testing the system. Do not use this fitting on pressurized supply lines.

Technical Specifications

• Material: ABS Plastic
• Connection Type: Hub (Solvent Weld)
• Fitting Type: Double Fixture Tee
• System Type: DWV (Drain, Waste, Vent)
• Inlet Size 1: 3 inches
• Inlet Size 2: 2 inches
• Outlet Size 1: 3 inches
• Outlet Size 2: 3 inches

Standard Information

• Brand: MUELLER STREAMLINE
• Manufacturer Part Number: ABSDBLFIX32