Mueller Streamline ABSBENDMS14SPH3 Abs Dwv 90 Deg Elbow 3 in

Product Description

The MUELLER STREAMLINE ABSBENDMS14SPH3 is a 3-inch ABS DWV 90-degree street elbow with a spigot x hub end connection. This fitting is designed to redirect drain, waste, and vent flow at a 90-degree angle within plastic DWV piping systems. The ABS construction handles a service temperature range of -40 degrees F to 180 degrees F, making it suitable for typical residential and light commercial plumbing applications. Licensed plumbers install this fitting as part of rough-in drain and vent work, connecting it inline where a sharp directional change is required.

This elbow is used in residential and light commercial drain, waste, and vent systems where ABS plastic pipe is the specified material. The spigot x hub configuration allows the spigot end to insert directly into the hub of an adjacent ABS fitting or pipe, eliminating the need for an additional coupling. It is well suited for new construction rough-in, remodel work, and repair or replacement of existing ABS DWV systems.

Key Features

• 90-degree street elbow configuration redirects DWV flow in a single fitting
• Spigot x hub end style integrates directly into standard ABS DWV pipe and fittings
• ABS material rated for service temperatures from -40 degrees F to 180 degrees F
• Listed to CSA B181.1, ASTM D2665, ASTM D3965, ASTM D2661, and ASTM D3311
• UL Listed 94V-0 flame classification
• NSF/ANSI Standard 14 certified and NSF U.P. Certified for drain, waste, and vent use
• Do not test or pressurize with compressed air or other gases

Compatibility

Designed as an OEM-style replacement and new-installation fitting for 3-inch ABS DWV piping systems meeting ASTM D2661 and D3311 standards.

Installation Notes

Installation should be performed by a licensed plumber in accordance with applicable local plumbing codes and the International Plumbing Code (IPC). Solvent-cement the spigot end and the mating hub using ABS-rated cement following the cement manufacturer's instructions and local code requirements. Shut off water supply and ensure the drain line is empty before cutting into an existing system. Do not use this fitting to carry compressed air, gas, or any pressurized fluid other than drain and waste flow.