Mueller Streamline ABSBENDMS142 Abs Dwv 90 Elbow 2 in

Product Description

The MUELLER STREAMLINE ABSBENDMS142 is a 2-inch ABS DWV 90-degree elbow fitting with a hub x hub connection. It is designed to change the direction of drain, waste, and vent flow in residential and light commercial plumbing systems. The fitting handles a service temperature range of -40 degrees F to 180 degrees F, making it suitable for typical interior DWV applications. Licensed plumbers and pipefitters install this type of fitting during rough-in work and remodel projects. It meets multiple industry standards including CSA B181.1, ASTM D2665, ASTM D3965, ASTM D2661, ASTM D3311, and carries a UL Listed 94V-0 rating and NSF/ANSI Standard 14 certification.

This elbow is used in residential and light commercial DWV piping systems where a 90-degree change in flow direction is required. Typical applications include drain stack offsets, under-sink drain routing, and branch connections in ABS piping systems. The hub x hub configuration accepts standard ABS pipe on both ends, allowing solvent-cement joints for a leak-resistant, permanent connection. It is not rated for use with compressed air or other gases and must only be used in drain, waste, and vent service.

Key Features

• 90-degree hub x hub configuration for directional flow change in DWV systems
• Service temperature range: -40 degrees F to 180 degrees F
• Meets CSA B181.1, ASTM D2665, ASTM D3965, ASTM D2661, and ASTM D3311 standards
• UL Listed 94V-0 flame rating
• NSF/ANSI Standard 14 and NSF U.P. Certified for potable water system drain applications
• Not approved for compressed air or gas pressure testing

Compatibility

Designed as an OEM-style replacement and standard-fit component for 2-inch ABS DWV piping systems in residential and light commercial plumbing applications.

Installation Notes

Installation should be performed by a licensed plumber in accordance with the IPC or applicable local plumbing codes. Before beginning work, ensure the existing drain line is depressurized and cleared of flow. Joints are made with ABS solvent cement following standard cure times before system use. Do not use this fitting for pressure testing with compressed air or any gas medium.