Mueller Streamline ABSBEND116SPH4 Abs Dwv Elbow 4 in

Product Description

The MUELLER STREAMLINE ABSBEND116SPH4 is a 4-inch ABS DWV 22-1/2 degree street elbow with a spigot x hub (Spg x H) connection configuration. It is used in drain, waste, and vent piping systems to redirect flow direction at a shallow 22-1/2 degree angle. Made from acrylonitrile butadiene styrene (ABS) plastic, this fitting is rated for service temperatures from -40 degrees F to 180 degrees F. Licensed plumbers and pipefitters install this fitting in residential and light commercial DWV applications where a gradual directional change is required.

This fitting is suited for drain, waste, and vent piping installations in residential and commercial buildings. The spigot x hub end configuration allows it to function as a street fitting, connecting directly into another hub without requiring a coupling. It is commonly used in below-slab, in-wall, and above-floor ABS DWV runs where a 22-1/2 degree offset is needed to route pipe around framing, footings, or other obstructions. This part belongs to the Series 5808-2 product line.

Key Features

• 22-1/2 degree street elbow provides a shallow directional change for precise DWV routing
• Spigot x hub end style allows direct socket-to-socket connection without additional fittings
• ABS construction rated from -40 degrees F to 180 degrees F service temperature
• Meets CSA B181.1, ASTM D2665, ASTM D3965, ASTM D2661, and ASTM D3311 standards
• UL Listed 94V-0 flame classification
• NSF/ANSI Standard 14 certified and NSF U.P. Certified for potable water system drain applications

Compatibility

Designed as an OEM-style replacement or new-installation fitting for 4-inch ABS DWV piping systems conforming to CSA B181.1 and ASTM D2661 standards.

Installation Notes

Installation should be performed by a licensed plumber in accordance with applicable local plumbing codes and the International Plumbing Code (IPC). Solvent-cement ABS fittings using ABS-compatible cement and primer per manufacturer instructions before joining. Do not use this fitting for pressure testing or service with compressed air or other gases. Ensure all DWV lines maintain proper slope and are fully supported per code requirements before backfilling or closing walls.