Msi Products Inc A20202322024 Reducing Tee 150lb Black

Product Description

The MSI PRODUCTS INC A20202322024 is a 150lb black malleable iron reducing tee designed to connect three sections of threaded pipe while transitioning to a smaller branch size. The fitting measures 2 inches on the run with a 1-1/4 inch inlet and a 1-1/2 inch branch outlet. Built to a heavy-pattern design, it delivers the structural integrity needed for everyday piping systems in plumbing, mechanical, and industrial applications. Threads conform to ASME B1.20.1, dimensions meet ASME B16.3, and the base material meets ASTM A197 specifications. Full lot traceability is available with material test reports on request. Licensed plumbers and pipefitters are the primary installers of this fitting.

This reducing tee suits residential and light commercial piping systems where a branch line must step down to a different pipe size without additional adapters or transitions. It is used in water supply, gas distribution, compressed air, and steam systems operating within the rated pressure range of 150 to 300 psi. The black finish indicates the fitting has not been galvanized, making it a common choice for gas and steam service. Its standardized threading and dimensions allow it to integrate directly into existing threaded-pipe configurations without special preparation.

Key Features

• Malleable iron heavy-pattern construction rated at 150 to 300 psi working pressure
• Conforms to ASME B16.3 dimensions, ASTM A197 material specification, and ASME B1.20.1 threading standards
• Reduces branch size in a single fitting, eliminating the need for additional couplings or adapters
• Full lot traceability with material test reports available upon request
• Manufactured in an ISO-certified facility for consistent dimensional and material quality
• Black finish suitable for gas, steam, and non-potable water service

Compatibility

Designed as a standard ASME B16.3 150lb malleable iron reducing tee for use in threaded-pipe systems requiring a 2 inch run with a 1-1/4 inch by 1-1/2 inch branch reduction.

Installation Notes

Installation should be performed by a licensed plumber or pipefitter in accordance with applicable codes, including the International Plumbing Code and International Fuel Gas Code where relevant. Shut off and depressurize the system completely before removing or installing any threaded fitting. Apply an appropriate thread sealant or PTFE tape to all male threads before assembly, and tighten to hand-tight plus the number of turns specified by your system design, taking care not to overtighten malleable iron fittings. Inspect threads for damage before installation to ensure a leak-free joint.