Milwaukee Tool 48-73-7124E Cut Resistant Gloves A2 2XL

Product Description

The MILWAUKEE TOOL 48-73-7124E is a cut- and puncture-resistant work glove designed for general-purpose trade use. Built on a polyethylene and nylon-spandex shell, it carries an ANSI/ISEA Cut Resistance Level A2 rating and an ANSI/ISEA Puncture Resistance Level 2 rating, making it suitable for handling sheet metal edges, conduit, and rough piping components. The nitrile dip on the thumb and index finger delivers targeted grip and abrasion resistance where contact and wear are most concentrated. Part of the SMARTSWIPE series, the glove weighs approximately 0.14 pounds per pair and fits both hands in a unisex sizing format.

These gloves are suited for residential and light commercial trade work including HVAC installation, electrical rough-in, plumbing, and general mechanical service. The elasticated wrist cuff keeps the glove seated during repetitive hand motion. The nylon and spandex back material provides dexterity for tasks requiring fine hand control, such as feeding wire, tightening fittings, or handling small fasteners. The SMARTSWIPE fingertip design is compatible with touchscreen devices, allowing techs to interact with phones or tablets without removing the glove.

Key Features

• ANSI/ISEA Cut Resistance Level A2 polyethylene shell construction
• ANSI/ISEA Puncture Resistance Level 2 rated
• Nitrile-dipped thumb and index finger for grip and abrasion protection
• ANSI/ISEA Abrasion Resistance Level 2
• Elasticated wrist cuff for secure fit during active use
• Nylon and spandex back and lining for flexibility and dexterity
• Unisex sizing available in 2X-Large

Compatibility

Designed as a general-purpose cut-resistant work glove suitable for HVAC, electrical, plumbing, and mechanical service applications requiring ANSI/ISEA A2 cut protection.

Installation Notes

Inspect gloves before each use for tears, punctures, or coating separation that could compromise protection. Cut-resistant gloves reduce laceration risk but do not eliminate it — always follow jobsite PPE requirements and applicable OSHA hand protection standards. Replace gloves when the nitrile coating shows significant wear or the shell material is visibly damaged.