Milwaukee Tool 48-73-7123E Cut Resistant Gloves Xl

Product Description

The MILWAUKEE TOOL 48-73-7123E is an ANSI/ISEA A2-rated cut and puncture resistant glove designed for general purpose trade work. Built on a polyethylene and nylon-spandex shell with nitrile dipping across the thumb and index finger, it delivers targeted grip and protection where hand contact is most frequent. The elasticated wrist cuff keeps the glove seated during tool handling and material staging. At 0.13 pounds per pair, it is light enough for extended wear across a full shift. Licensed HVAC technicians, electricians, plumbers, and general trade workers install this glove as part of everyday hand protection protocol.

This glove is sized X-Large and is sold as a pair, making it a direct one-for-one replacement or stock replenishment item for jobsite PPE kits. The SMARTSWIPE series designation indicates touchscreen-compatible fingertip material, allowing interaction with tablets and smartphones without removing the glove. It suits residential and light commercial settings where workers handle sheet metal, conduit, pipe fittings, fasteners, and similar materials that present cut and abrasion risk.

Key Features

• ANSI/ISEA Cut Resistance Level A2 for protection against sharp edges on metal, conduit, and fittings
• ANSI/ISEA Puncture Resistance Level 2 reduces risk from wire ends, fasteners, and sheet metal burrs
• ANSI/ISEA Abrasion Resistance Level 2 extends glove service life under routine handling tasks
• Nitrile dipped coating on thumb and index finger improves grip on wet or oily surfaces
• SMARTSWIPE touchscreen-compatible fingertips for use with mobile devices without removing gloves
• Elasticated wrist cuff provides a secure, stay-put fit during active work

Compatibility

Designed as a general purpose cut and puncture resistant work glove suitable for trade professionals requiring ANSI/ISEA A2-level hand protection in HVAC, electrical, plumbing, and light construction applications.

Installation Notes

Inspect gloves before each use for tears, punctures, or degraded coating that would compromise protection. Do not use damaged gloves where cut or puncture hazards are present. Gloves should be selected as part of a complete PPE program in compliance with OSHA 29 CFR 1910.138 personal protective equipment standards. Replace gloves when coating wear, cuts, or abrasion reduce the protection level below task requirements.