Milwaukee Tool 48-32-4801 Phillips Bit Size 1 6 Inch

Product Description

The MILWAUKEE TOOL 48-32-4801 is a Number 1 Phillips screwdriver bit built for use with 1/4 inch hex drive power tools and impact drivers. At 6 inches in overall length, the bit provides extended reach for fastening in recessed or hard-to-access areas where a standard-length bit falls short. Constructed from steel, it delivers the durability needed for repetitive fastening tasks on the job site. This bit is a common accessory for electricians, HVAC technicians, plumbers, and general contractors who rely on cordless drills and impact drivers throughout their daily work.

This bit is suited for residential and commercial trade applications where a Number 1 Phillips drive is required. The 6 inch length is especially useful when driving screws into electrical boxes, HVAC panels, duct fasteners, or control board enclosures where standard-length bits cannot reach. It fits any 1/4 inch hex quick-change chuck, making it compatible with the wide range of cordless tools found on trade job sites.

Key Features

• Number 1 Phillips tip for precise fit in matching fastener heads
• 1/4 inch hex drive for use with standard quick-change chucks
• 6 inch overall length provides extended reach in confined spaces
• Steel construction for durability under repeated use
• Compact single-piece format for quick swapping between drivers

Compatibility

Designed as a direct-fit replacement or supplemental bit for any tool accepting a standard 1/4 inch hex drive, including cordless drills, impact drivers, and right-angle attachments commonly used in trade work.

Installation Notes

Insert the bit firmly into the 1/4 inch hex chuck before operating the tool. Confirm the point size matches the fastener recess before driving to avoid stripping. When working near energized electrical panels or control boards, follow NFPA 70E arc flash and shock hazard protocols and de-energize equipment where required. Inspect the bit tip for wear or rounding before each use and replace if the tip no longer seats squarely in the fastener head.