Milwaukee Tool 48-20-8076 Sds-plus Drill Bit 16mm

Product Description

The MILWAUKEE TOOL 48-20-8076 is a carbide-tipped rotary hammer drill bit designed for use with SDS-Plus rotary hammers. Built on a high-speed steel body with a carbide-tipped spear cutting shape, this bit is engineered to bore through concrete, masonry, and similar hard substrates. The 16mm diameter combined with a 160mm usable flute length allows for consistent material removal at depth. Weighing 0.34 pounds, it is a standard single-bit offering suited for field technicians, electricians, plumbers, and general contractors who work with SDS-Plus hammer tools on structural penetration tasks.

This bit fits SDS-Plus rotary hammers and is appropriate for residential and light commercial applications where 16mm holes are required in concrete, block, or masonry. Typical use cases include anchor bolt holes, conduit penetrations, pipe sleeve openings, and mechanical fastener installations. It is packaged as a single bit, making it a direct replacement or supplemental addition to an existing bit set.

Key Features

• 16mm cutting diameter for anchor and sleeve hole applications
• Carbide-tipped spear cutting shape for aggressive penetration into concrete and masonry
• High-speed steel body construction for durability under rotary hammer impact loads
• 160mm usable flute length for adequate drilling depth on most structural penetrations
• SDS-Plus shank provides secure chuck engagement without tool-free bit slip
• 210mm overall length fits standard SDS-Plus rotary hammer chucks

Compatibility

Designed for use with SDS-Plus rotary hammers. The SDS-Plus shank is a widely adopted standard across rotary hammer tool platforms used in commercial and residential construction trades.

Installation Notes

Installation is performed by licensed tradespeople including electricians, plumbers, and mechanical contractors using SDS-Plus rotary hammers. Before drilling, confirm the work area is clear of embedded conduit, rebar, or utility lines using a scanning tool. Insert the bit fully into the SDS-Plus chuck until it locks, and verify seating before operation. Follow applicable codes including NEC and IPC for penetration sizing and sleeving requirements.