Milwaukee Tool 48-13-7805 Utility Auger Bit 11/16 Inch

Product Description

The MILWAUKEE TOOL 48-13-7805 is a Shockwave Impact Duty utility auger bit designed for drilling through wood and wood-composite materials in demanding trade applications. Built with a carbide-tipped cutting edge and high-speed steel body, it delivers general-purpose hole drilling at 11/16 inch (0.6875 inches) diameter. The 7/16 inch (0.4375 inches) hex shank is engineered for use with hex-drive impact drivers and drill drivers. With an overall length of 22.00 inches and a flute length of 6.22 inches, this bit reaches into deep framing cavities and wall bays where shorter bits fall short. Licensed electricians, plumbers, and HVAC installers use this bit to run wire, pipe, and tubing through structural members.

This auger bit is suited for residential and light commercial rough-in work where trade professionals need to bore through studs, joists, plates, and headers. Typical applications include electrical rough-in for wire runs, plumbing rough-in for supply and drain lines, and HVAC low-voltage and refrigerant line routing through framing. The Shockwave Impact Duty series is built to handle the torque output of impact drivers, making it a practical choice for crews using cordless impact tools on the job site. Right-hand cutting direction is standard for conventional drill operation.

Key Features

• Carbide-tipped cutting edge for extended durability in abrasive materials
• 11/16 inch (0.6875 inches) hole diameter for wire, pipe, and line routing
• 7/16 inch hex shank compatible with impact drivers and hex-chuck drill drivers
• 22.00 inch overall length reaches deep into wall and floor cavities
• Shockwave Impact Duty series construction rated for impact driver torque loads
• Right-hand cut with standard point geometry for general-purpose drilling

Compatibility

Designed for use with impact drivers and drill drivers equipped with a 7/16 inch hex chuck. Suitable for general-purpose drilling applications in wood framing, engineered lumber, and wood composites encountered in residential and light commercial construction.

Installation Notes

This bit is installed and operated by licensed electricians, plumbers, HVAC technicians, and general contractors performing rough-in work. Ensure the hex shank is fully seated and locked in the chuck before operation. Wear appropriate eye protection when drilling overhead or into materials with unknown embedded fasteners. Follow applicable codes — NEC, IPC, or IFGC as relevant to the trade — for required hole sizing, edge distances, and protection requirements when boring through structural members.