Midland Industries FS25012424 90 Degree Orfs Mip Elbow

Product Description

The MIDLAND INDUSTRIES FS25012424 is a 90-degree hydraulic elbow adapter designed to connect a 2-inch Male O-Ring Face Seal (ORFS) fitting to a 1-1/2-inch Male Iron Pipe (MIP) port. Built from steel, this adapter belongs to the FS2501 Series of MORFS-to-Male Pipe elbows. It carries a maximum operating pressure rating of 3000 psi and is rated for service up to 375 degrees F. The ORFS end uses a 2-12 thread and the MIP end uses a 1-1/2-11-1/2 thread. It is installed by hydraulic system technicians and fluid power mechanics working on industrial or mobile hydraulic circuits.

This elbow adapter is used in steel hydraulic plumbing applications where a rigid 90-degree direction change is needed between an ORFS port and a male pipe fitting. The ORFS connection style eliminates the reliance on thread deformation for sealing, using a flat face and O-ring to deliver a leak-resistant joint under high pressure. Typical install scenarios include mobile equipment, industrial machinery, and hydraulic power units where space constraints require angled routing. The dash-24 designation indicates this is a large-bore adapter suited for high-flow circuits.

Key Features

• 90-degree elbow configuration routes hydraulic lines in tight or angled installations
• 2-inch Male ORFS connection on one end for O-ring face seal integrity
• 1-1/2-inch MIP connection on the opposing end for standard pipe thread ports
• Rated to 3000 psi maximum operating pressure for high-pressure hydraulic service
• Temperature rated to 375 degrees F for demanding thermal environments
• Steel construction for durability in hydraulic plumbing applications

Compatibility

Designed as an OEM-style hydraulic adapter for steel O-ring face seal plumbing systems requiring a 90-degree MORFS-to-male pipe transition in dash-24 sizing.

Installation Notes

Installation should be performed by a qualified hydraulic technician or fluid power specialist. Depressurize and isolate the hydraulic circuit completely before removing or installing any fittings. Inspect the O-ring sealing surface for nicks or damage prior to assembly, and always use a new, properly seated O-ring on the ORFS face. Torque fittings according to the system manufacturer's specifications and verify the circuit for leaks before returning to service.