Midland Industries D6500-S12-S12 90-degree Swivel Elbow

Product Description

The MIDLAND INDUSTRIES D6500-S12-S12 is a 90-degree swivel elbow fitting designed for steel metric compression hydraulic lines. It connects an S12 Metric Bite Type port to an S12 Female Metric Swivel port, with both threads sized at M20 x 1.5. The fitting is manufactured from steel with a trivalent chromium zinc-plated finish for corrosion resistance. Built to DIN 2353 and ISO 8434-1 dimension standards, it carries an anticipated pressure rating of 63 MPa. Center-to-end dimensions measure 38 x 31 mm. This fitting is installed by hydraulic technicians and fluid power mechanics working on industrial and mobile hydraulic systems.

The D6500-S12-S12 is suited for hydraulic plumbing applications where a 90-degree directional change is required in a metric compression fitting circuit. It is commonly used in industrial machinery, mobile equipment, and hydraulic power units where DIN-spec fittings are specified. The swivel design on the female end simplifies assembly by allowing the fitting to rotate during tightening, reducing the risk of line twist in tight installation spaces.

Key Features

• 90-degree swivel elbow configuration for directional routing in hydraulic lines
• S12 Metric Bite Type x S12 Female Metric Swivel connection ends
• M20 x 1.5 thread size on both ports
• Conforms to DIN 2353 and ISO 8434-1 dimension standards
• Trivalent chromium zinc-plated steel construction for corrosion resistance
• 63 MPa anticipated pressure rating

Compatibility

Designed as a DIN 2353 and ISO 8434-1 compliant replacement or addition for S12 metric bite type hydraulic compression fitting circuits using M20 x 1.5 threaded connections.

Installation Notes

Installation should be performed by a qualified hydraulic technician or fluid power mechanic. Depressurize and fully isolate the hydraulic system before removing or installing any fittings. Use the appropriate metric torque wrench and follow DIN 2353 assembly procedures for bite-type fittings, including proper presetting of the cutting ring where required. Do not over-tighten the swivel end; the rotating feature is intended to relieve line stress during assembly, not to substitute for proper line routing.