Midland Industries CGC-150CR-A1 Cam Groove Crimplok Coupler

Product Description

The MIDLAND INDUSTRIES CGC-150CR-A1 is a Type C Cam and Groove Crimplok coupler designed for quick-connect hose assembly applications. One end features a 1-1/2 inch female cam and groove coupler, and the other end terminates in a 1-1/2 inch hose shank barb for use with compatible Crimplok ferrules. Cast from aluminum, this coupler is rated to a maximum operating pressure of 250 psi and is built to handle a wide temperature range. An NBR gasket is installed for fluid sealing. Plumbers, industrial maintenance technicians, and hose assembly specialists working with cam and groove systems are the typical end users for this fitting.

This coupler is suited for fluid transfer lines in industrial, agricultural, and commercial service environments where cam and groove quick-disconnect couplings are standard. The hose shank end accepts a Crimplok ferrule for a permanent, crimped hose termination, making it a common choice for high-cycle connections where reliability and fast disconnection are both required. It is appropriate for use in both above-ground and equipment-mounted hose assemblies.

Key Features

• Type C cam and groove configuration with 1-1/2 inch female coupler on one end
• 1-1/2 inch hose shank barb on the opposite end for crimped ferrule termination
• Aluminum casting rated for casting temperatures from -150 to 250 degrees F
• NBR gasket rated for gasket operating temperatures from -40 to 212 degrees F
• Maximum operating pressure of 250 psi
• Designed for use with CRIMPLOK Ferrules CF-XXXXX-SS304

Compatibility

Designed for use with CRIMPLOK Ferrules CF-XXXXX-SS304. Fits standard Type C cam and groove hose assemblies accepting 1-1/2 inch female coupler connections with crimped hose shank terminations.

Installation Notes

Installation is performed by hose assembly technicians or plumbing and industrial maintenance professionals. Depressurize and drain all lines fully before disconnecting or replacing any cam and groove fitting. The hose shank end requires a compatible Crimplok ferrule and a hydraulic crimping tool rated for the ferrule specification. Verify that the NBR gasket is correctly seated before applying system pressure, and confirm that the assembled hose rating meets or exceeds the 250 psi system operating pressure.