Midland Industries 95330 Rubber Lined Clamp Steel

Product Description

The MIDLAND INDUSTRIES 95330 is a rubber lined steel clamp designed for secure pipe and conduit mounting in mechanical and plumbing installations. The rubber lining cushions the clamped surface, reducing vibration transmission and protecting the pipe exterior from abrasion and corrosion contact. Built from steel with an aluzinc-style finish for corrosion resistance, this clamp handles a 2-15/16 inch nominal pipe or tube diameter. It is sized for a 0.26 inch mounting hole and weighs approximately 0.11 pounds, making it a lightweight but durable hardware component suited for HVAC, plumbing, and general mechanical mounting applications.

This clamp is used in residential and light commercial installations where pipes, conduit, or tubing must be secured to structural supports, hangers, or framing. The rubber lining makes it well suited for copper, steel, or plastic pipe runs where surface protection and vibration dampening are priorities. Plumbers, pipefitters, and HVAC technicians typically use this style of clamp when routing refrigerant lines, domestic water piping, or drain lines along walls, joists, or equipment frames.

Key Features

• Rubber lining cushions pipe surface and dampens vibration
• Steel construction with corrosion-resistant aluzinc finish
• 2-15/16 inch nominal pipe diameter sizing
• 0.26 inch mounting hole diameter for standard fastener compatibility
• Lightweight at 0.11 pounds for easy one-hand installation
• Single-piece clamp design for straightforward mounting

Compatibility

Designed as an OEM-style mounting clamp for 2-15/16 inch nominal pipe and tubing in residential and commercial HVAC, plumbing, and mechanical systems.

Installation Notes

Installation is typically performed by licensed plumbers, pipefitters, or HVAC technicians. Power down or isolate any systems before securing live refrigerant or pressurized pipe runs. Fasten through the 0.26 inch mounting hole using an appropriately rated screw or bolt into solid backing such as a joist, stud, or unistrut channel. Follow applicable IPC or IFGC guidelines for pipe support spacing and fastener requirements.