Midland Industries 88085 Worm Gear Hose Clamp Sae 44

Product Description

The MIDLAND INDUSTRIES 88085 is an embossed worm gear hose clamp designed to secure hose connections across a range of nominal diameters from 2-11/16 inches to 3-3/8 inches. The embossed band design distributes clamping force evenly around the hose to reduce cutting and deformation at the clamp seat. Constructed from steel with an Aluzinc finish for corrosion resistance, this clamp measures 12 mm in band width and falls under SAE Size 44. It is suited for plumbing, HVAC, and general industrial hose assemblies where a reliable worm-drive fastening method is required.

This clamp is appropriate for use in residential and light commercial applications wherever a hose or flexible connection must be held firmly to a barbed or smooth fitting. Typical installation scenarios include HVAC condensate lines, water supply and drain hose connections, and general fluid-transfer assemblies. The non-perforated, lined band style makes it a good fit for softer hose materials where a standard perforated clamp could cause damage over time.

Key Features

• Embossed worm-drive band distributes clamping load evenly to protect hose integrity
• Clamp range: 2-11/16 inches minimum to 3-3/8 inches maximum diameter
• 12 mm band width for a stable, low-profile seating footprint
• SAE Size 44 classification for straightforward cross-reference and replacement
• Steel construction with Aluzinc finish for corrosion resistance in wet or humid environments
• Non-perforated lined band reduces hose surface damage during tightening

Compatibility

Designed as an OEM-style replacement or direct-use worm gear hose clamp for any hose or fitting with an outer diameter falling between 2-11/16 inches and 3-3/8 inches, consistent with SAE Size 44 specifications.

Installation Notes

Installation is typically performed by plumbers, HVAC technicians, or general maintenance trades using a standard flat-blade or hex-drive screwdriver. Shut off fluid flow and depressurize the line before removing an existing clamp or seating a new one. Position the clamp band fully over the hose-to-fitting overlap zone before tightening the worm screw. Do not overtighten to the point of deforming the hose wall, especially on softer elastomeric materials.