Midland Industries 77559 Copper Reducing Tee 2x1x2 in

Product Description

The MIDLAND INDUSTRIES 77559 is a copper reducing tee fitting designed for sweat (solder) connections in plumbing and hydronic piping systems. It features a 2-inch by 1-inch by 2-inch configuration, with the branch outlet reduced to 1 inch to allow a step-down in line size without adding additional fittings. Rated to 500 psi and suitable for service from 32 to 200 degrees F, this fitting handles domestic water, heating, and light commercial plumbing applications. Licensed plumbers and pipefitters install this fitting using standard soldering techniques per applicable code requirements.

This reducing tee is used in residential and light commercial copper piping systems where a main run must branch to a smaller supply line. Common applications include domestic hot and cold water distribution, hydronic heating loops, and general plumbing rough-in work. The sweat connection style requires flux and solder, making it compatible with standard Type L and Type M copper tube. It is well suited for new construction as well as retrofit and repair work where a reduction in branch line size is needed.

Key Features

• Copper construction provides corrosion resistance and long service life in water systems
• Sweat (C x C x C) connection on all three ports for soldered joints
• 2 in x 1 in x 2 in reducing configuration reduces branch line without additional fittings
• 500 psi pressure rating for reliable performance in high-pressure domestic water systems
• Rated for service from 32 to 200 degrees F covering standard plumbing temperature ranges

Compatibility

Designed as an OEM-style sweat fitting for use with standard copper tube in residential and light commercial plumbing and hydronic piping systems.

Installation Notes

Installation should be performed by a licensed plumber in accordance with the International Plumbing Code (IPC) and applicable local codes. Shut off and drain the water supply before cutting into existing piping. Clean all tube ends and fitting cups thoroughly, apply flux evenly, and use lead-free solder rated for potable water service where required. Avoid overheating the fitting during soldering, as excessive heat can damage the fitting and produce poor joint quality.