Midland Industries 77228 No Stop Coupling 2-1/2 in Copper

Product Description

The MIDLAND INDUSTRIES 77228 is a 2-1/2 inch no stop coupling designed for copper sweat (solder) piping systems. Unlike standard couplings, the no stop design lacks an internal center stop, allowing the fitting to slide freely along the pipe. This makes it the correct choice for repair situations where a damaged section of pipe must be replaced and a standard coupling cannot be advanced into position. The fitting is full copper construction, compatible with standard sweat soldering practices. It is typically installed by licensed plumbers working on residential or light commercial water distribution, hydronic heating, or similar copper piping systems.

This coupling is used in applications where two lengths of copper pipe must be joined without a center stop restriction. Common scenarios include in-line pipe repairs, extensions, and retrofits on 2-1/2 inch copper systems. The slip design allows the fitting to be positioned over one pipe end and slid back into final position after the repair cut is made, which is standard practice in repair coupling applications across plumbing and hydronic systems.

Key Features

• No stop (slip) design allows free axial movement along pipe for repair installations
• 2-1/2 inch connection size on both ends for same-size pipe joining
• Copper construction compatible with standard lead-free solder and flux
• Compact profile at approximately 3 inches in length
• Low minimum order quantity suitable for single-fitting repair jobs

Compatibility

Designed as an OEM-style replacement and repair fitting for 2-1/2 inch copper sweat piping systems in residential and commercial plumbing and hydronic heating applications.

Installation Notes

Installation is performed by a licensed plumber following applicable IPC or local plumbing code requirements. Shut off and drain the water supply before cutting into any existing piping. Clean and debur both pipe ends, apply approved lead-free flux, and solder using standard sweat soldering technique. Do not apply heat to the fitting before flux is applied, and allow the joint to cool completely before restoring system pressure.