Midland Industries 76060 Aluminum Close Nipple 1/2 in Mpt

Product Description

The MIDLAND INDUSTRIES 76060 is a close-pattern aluminum pipe nipple with 1/2 in male pipe thread (MPT) connections on both ends. Close nipples have no exposed center pipe length - the two threaded ends meet at the center, making them the shortest possible nipple for a given thread size. This fitting is used to connect two female-threaded fittings with minimal spacing between them. At 0.02 pounds, the aluminum construction keeps weight low and eliminates corrosion concerns in moisture-prone environments. Licensed plumbers and pipefitters install this fitting in low-pressure fluid and gas piping systems where a tight, compact connection is required.

This nipple is suited for residential and light commercial piping applications including water supply lines, irrigation systems, compressed air distribution, and other low-pressure service where aluminum is an appropriate material. The 1/2 in NPT thread size is one of the most common in trade plumbing and light mechanical work. The close-length pattern is typically selected when space is constrained or when a direct back-to-back coupling of two fittings is needed without any standoff.

Key Features

• Close-pattern nipple - no exposed center pipe, minimum overall length
• Both ends: 1/2 in male pipe thread (MPT), 1/2-14 thread form
• Aluminum construction - lightweight and corrosion resistant
• Compact footprint: approximately 1.05 inches in length, 0.75 inches wide
• Minimum order quantity of 1 - available for single-unit purchase

Compatibility

Designed as a standard 1/2 in NPT close nipple for use with any female-threaded fitting or valve conforming to 1/2-14 NPT thread specifications in aluminum-compatible piping systems.

Installation Notes

A licensed plumber or pipefitter should install this fitting in accordance with applicable local plumbing codes and IPC guidelines. Shut off and depressurize the line before making any threaded connections. Apply an appropriate thread sealant or PTFE tape to the male threads before assembly. Do not over-torque aluminum fittings, as the material is softer than steel and prone to thread damage under excessive force.