Midland Industries 73356BM Polyurethane Tubing 10mm Od 100m

Product Description

The MIDLAND INDUSTRIES 73356BM is a black polyurethane tubing rated for demanding pneumatic and fluid transfer applications. It measures 6.5mm inside diameter and 10mm outside diameter, with a 1.75mm wall thickness. The 100-meter coil delivers a working pressure of 150 psi with a 3:1 safety factor, plus a 28 inHg vacuum rating. Shore A 98 hardness gives this tubing strong kink resistance and durability under repeated flexing. HVAC technicians, pneumatic system installers, and industrial service pros use this tubing where reliable, continuous-length runs are required without frequent splicing.

This tubing is suited for pneumatic control lines, compressed air distribution, and fluid transfer in both light commercial and industrial settings. A minimum bend radius of 25mm keeps routing flexible in tight spaces. Its temperature range of -40 to 150 degrees F makes it appropriate for outdoor runs, cold storage environments, and heated equipment enclosures. It is compatible with push-to-connect fittings, barb-type fittings, and compression fittings, making it straightforward to terminate with common trade hardware.

Key Features

• 150 psi working pressure with a 3:1 safety factor for dependable service margin
• 28 inHg vacuum rating supports both pressure and suction line applications
• Shore A 98 hardness provides strong resistance to abrasion, kinking, and deformation
• Rated from -40 to 150 degrees F for wide environmental range
• 25mm minimum bend radius allows tight routing in confined installations
• 100-meter continuous coil reduces splice points on long runs
• Resistant to abrasion, chemicals, cold, heat, and kinking

Compatibility

Designed for use with push-to-connect fittings, barb-type fittings, and compression fittings commonly used in pneumatic and fluid transfer systems.

Installation Notes

Installation should be performed by a qualified technician familiar with pneumatic or fluid transfer systems. Depressurize and lock out the system before cutting or connecting tubing. Use a clean, square cut to ensure a proper seal at push-to-connect or compression fittings. Do not exceed the rated working pressure or bend the tubing below the 25mm minimum bend radius.