Midland Industries 73352Y Polyurethane Tubing 6mm Od 100ft

Product Description

The MIDLAND INDUSTRIES 73352Y is a yellow polyurethane tubing rated for demanding pneumatic and fluid transfer applications in industrial and commercial environments. With a 6 mm outer diameter, 4 mm inner diameter, and 1 mm wall thickness, this tubing handles working pressures up to 180 psi and carries a 3:1 safety factor. A Shore A hardness rating of 98 gives it firm resistance to kinking, abrasion, and chemical exposure while remaining flexible enough for routed installations. The 12 mm minimum bend radius limits tight-corner installation risk. Temperature range spans -40 to 150 degrees F, making it suitable for both cold-environment and heated-space service. Licensed trades and industrial maintenance technicians are the typical installers.

This tubing is designed for use with push-to-connect fittings as well as barb-type and compression fittings, covering the most common connection styles found in pneumatic control lines, automation systems, and light fluid transfer circuits. The 100-foot coil length supports long runs without mid-run splices. Its resistance to abrasion, chemicals, cold, heat, and kinking makes it a reliable choice for factory floors, equipment bays, and mechanical rooms where tubing takes repeated mechanical and environmental stress. A vacuum rating of 28 inHg also allows use in suction-line configurations.

Key Features

• Working pressure rated to 180 psi with a 3:1 safety factor
• Shore A 98 hardness for kink and abrasion resistance
• Operating temperature range: -40 to 150 degrees F
• Compatible with push-to-connect, barb-type, and compression fittings
• 28 inHg vacuum rating supports suction-line use
• 12 mm minimum bend radius for controlled routing in tight spaces
• 100-foot coil minimizes splice points on long runs

Compatibility

Designed for use with push-to-connect fittings, barb-type fittings, and compression fittings in pneumatic and fluid transfer systems.

Installation Notes

Shut off the air or fluid supply and bleed system pressure to zero before cutting or connecting tubing. Use a clean, straight tubing cut to ensure a proper seal at push-to-connect and compression fittings - a ragged or angled cut is a common cause of leaks. Respect the 12 mm minimum bend radius during routing to avoid wall stress and premature failure. Verify fitting compatibility with 6 mm OD tubing before installation.