Midland Industries 704049-0806 Flare Male Elbow Brass

Product Description

The MIDLAND INDUSTRIES 704049-0806 is a lead-free brass SAE 45-degree flare, 90-degree male elbow fitting designed for connecting copper, brass, aluminum, or steel tubing to threaded pipe systems. It features a 1/2-inch male flared connection on one end and a 3/8-inch male NPTF connection on the other, with a thread specification of 3/4-16 on the flare side and 3/8-18 on the NPTF side. The 90-degree turn makes it well suited for routing lines in tight spaces without bending the tubing. Lead-free brass construction meets material requirements for potable water and refrigerant service applications where lead-free compliance is mandated.

This fitting is used in plumbing, HVAC, and refrigeration installations where a direction change is needed between a flared tubing run and a male-threaded port. Typical applications include gas line connections, refrigerant line sets, and fuel or oil distribution systems. The SAE 45-degree flare interface provides a reliable metal-to-metal seal when properly torqued, making it a standard choice for licensed plumbers and HVAC technicians working on residential and light commercial systems. The fitting is rated for temperatures from -40 degrees F to 250 degrees F, covering a broad range of service conditions.

Key Features

• Lead-free brass construction meets lead-free compliance requirements for applicable installations
• SAE 45-degree flare connection on the 1/2-inch side provides a reliable metal-to-metal seal
• 3/8-inch male NPTF thread on the secondary end for secure tapered pipe thread engagement
• 90-degree elbow geometry allows directional changes without bending tubing
• Compatible with copper, brass, aluminum, and steel tubing
• Rated from -40 degrees F to 250 degrees F for broad service range

Compatibility

Designed for use with copper, brass, aluminum, and steel tubing in SAE 45-degree flare systems requiring a 1/2-inch male flared to 3/8-inch male NPTF transition with a 90-degree change in direction.

Installation Notes

This fitting is typically installed by licensed plumbers or HVAC technicians. Shut off all pressure to the line and relieve any residual gas, refrigerant, or fluid before beginning work. Ensure the tubing end is properly flared to SAE 45-degree specification using a calibrated flaring tool before making up the connection. Hand-tighten both connections before applying final torque, and inspect for leaks after restoring service pressure.