Midland Industries 700072-0202 Brass Branch Tee

Product Description

The MIDLAND INDUSTRIES 700072-0202 is a lead-free brass branch tee fitting designed for low-pressure fluid and gas distribution lines. It joins three lines using a combination of compression and male pipe thread connections: two 1/8-inch compression ports and one 1/8-inch male pipe thread (MPT) outlet. The fitting uses a 5/16-24 by 1/8-27 thread specification and is rated for temperatures from -40 degrees F to 250 degrees F. Its compact brass construction makes it suitable for tight installations where a reliable three-way split is required. Licensed plumbers and HVAC technicians are the primary installers for this type of fitting.

This branch tee is suited for residential and light commercial plumbing, refrigeration, and HVAC applications where a three-way connection is needed in a small-diameter line. It is compatible with copper, aluminum, or plastic tubing on the compression ends. The MPT port allows direct threaded connection to a female-threaded valve, manifold, or instrument port. Typical use cases include instrument tap-offs, control line branches, and sensing line distribution in low-pressure systems.

Key Features

• Lead-free brass construction meets potable water and plumbing code requirements
• Two 1/8-inch compression inlets accept copper, aluminum, or plastic tubing
• 1/8-inch MPT outlet for direct threaded connection to valves or manifolds
• Rated from -40 degrees F to 250 degrees F for a wide service temperature range
• 5/16-24 by 1/8-27 thread specification for precise fitment
• Compact profile at 1.6 inches length and 0.8 inches width for tight spaces

Compatibility

Compatible with copper, aluminum, or plastic tubing on compression connection ports. Suitable as a branch fitting in low-pressure plumbing, HVAC control lines, and instrumentation circuits using 1/8-inch tubing and 1/8-inch NPT threaded components.

Installation Notes

Installation should be performed by a licensed plumber or qualified HVAC technician in accordance with applicable local plumbing codes. Shut off and depressurize the supply line completely before disassembly or fitting installation. Compression fittings should be hand-tightened first, then turned with a wrench to the appropriate snug fit without over-torquing, which can crack ferrules or deform soft tubing. Do not use pipe dope on compression connections; thread sealant may be applied to the MPT port threads only.