Midland Industries 6802NWO810 45-deg Elbow Jic O-ring Boss

Product Description

The MIDLAND INDUSTRIES 6802NWO810 is a 45-degree elbow hydraulic adapter fitting machined from steel for use in high-pressure hydraulic systems. It connects a 1/2-inch Male JIC end (3/4-16 thread) to a 5/8-inch Male Adjustable O-Ring Boss end (7/8-14 thread). The adjustable O-Ring Boss port allows for precise directional positioning during installation without compromising the seal. Rated to 3600 psi maximum operating pressure and suitable for service up to 375 degrees F, this fitting is built for demanding hydraulic circuit applications. Licensed hydraulic technicians and fluid power specialists are the typical installers of this component.

This fitting is used in steel hydraulic line assemblies where a 45-degree change of direction is required between a JIC flare connection and an adjustable O-Ring Boss port. It is well suited for mobile equipment, industrial machinery, and fluid power systems where high-cycle or high-pressure performance is required. The 6802-NWO series covers MJIC to Male Adjustable O-Ring 45-degree elbow configurations, making this part a direct catalog selection for that adapter geometry.

Key Features

• 45-degree elbow geometry routes hydraulic lines with a controlled directional change
• 1/2-inch Male JIC (3/4-16 thread) on one end for standard flare-seat connections
• 5/8-inch Male Adjustable O-Ring Boss (7/8-14 thread) on the second end for leak-resistant port sealing
• Maximum operating pressure of 3600 psi; non-adjustable configuration rated 3600 to 4500 psi
• Rated for operating temperatures up to 375 degrees F
• Steel construction for durability in high-pressure hydraulic service

Compatibility

Designed for use in steel hydraulic plumbing assemblies requiring a MJIC to Male Adjustable O-Ring Boss 45-degree elbow adapter. Suitable for systems using 3/4-16 JIC and 7/8-14 O-Ring Boss port threads.

Installation Notes

Installation should be performed by a qualified hydraulic technician or fluid power specialist. Depressurize and de-energize the hydraulic system completely before disconnecting or installing any fitting. The adjustable O-Ring Boss end must be backed off and re-torqued to the desired port orientation before final tightening - do not rotate after the O-ring has been fully seated under load. Follow applicable fluid power standards and equipment manufacturer torque guidelines for final assembly.