Midland Industries 65533DT Double Tapped Bushing 2.5x1.25 in

Product Description

The MIDLAND INDUSTRIES 65533DT is a black malleable iron double tapped bushing used to reduce a larger female threaded opening to a smaller male threaded connection in piping systems. It features a 2-1/2 inch male pipe thread (MPT) on the outer end and a 1-1/4 inch female pipe thread (FPT) on the inner bore, allowing inline size reduction without adding a separate coupling. Rated at 150 psi and built to ANSI B16.3 dimensional standards, it is suited for steam, water, gas, and air service across a wide temperature range. Licensed plumbers and pipefitters are the typical installers for this fitting class.

This double tapped bushing is used in residential and commercial plumbing, gas distribution, and mechanical piping systems wherever a 2-1/2 inch threaded port must be reduced to accept 1-1/4 inch pipe or fittings. Its black iron finish makes it a common choice in natural gas and propane supply lines, as well as in fire protection and industrial fluid systems. The malleable iron construction handles thermal cycling and mechanical stress better than standard cast iron, making it appropriate for systems with moderate vibration or temperature variation.

Key Features

• 2-1/2 inch MPT outer thread reduces to 1-1/4 inch FPT inner thread in a single fitting
• Malleable iron construction rated for 150 psi working pressure
• Meets ANSI B16.3 dimensional standards for 150-class malleable iron fittings
• Rated for service from -20 degrees F to 350 degrees F
• Black finish suitable for gas, steam, water, and compressed air service

Compatibility

Designed as an OEM-style replacement or new-installation fitting for 150-pound malleable iron threaded piping systems conforming to ANSI B16.3 standards.

Installation Notes

Installation is typically performed by a licensed plumber or pipefitter. Shut off and depressurize the system completely before removing or installing any threaded fitting. Apply a code-approved pipe thread sealant or PTFE tape to male threads before assembly, and tighten to wrench-tight per applicable IPC or IFGC requirements. Do not over-tighten malleable iron fittings, as the material can crack under excessive torque.