Midland Industries 650800C Dot 90 Deg Union Elbow 1/2 in Ptc

Product Description

The MIDLAND INDUSTRIES 650800C is a D.O.T.-rated 90-degree union elbow fitting designed for push-to-connect pneumatic and fluid system applications. Built with a composite body, this fitting accepts 1/2-inch push-to-connect tubing on both ends, allowing a direction change without tools or thread sealant. It is rated for 145 psi and an operating temperature range of -40 to 140 degrees F. The composite construction keeps weight low while maintaining pressure integrity. This type of fitting is commonly installed by plumbers, HVAC technicians, and fleet maintenance professionals working on air brake lines, pneumatic controls, and compressed-air distribution systems.

The 650800C is suited for use in light commercial and industrial pneumatic plumbing where a 90-degree change of direction is required in a push-to-connect tubing run. Its D.O.T. compliance makes it appropriate for air brake and vehicle air system applications where federal safety standards apply. The fitting works in both new installations and service replacements where quick, tool-free assembly is a priority. Its compact footprint fits tight routing paths in equipment bays and mechanical rooms.

Key Features

• D.O.T.-rated composite body construction for air brake and pneumatic system use
• 90-degree union elbow allows direction change with push-to-connect convenience on both ends
• Rated to 145 psi working pressure
• Operating temperature range of -40 to 140 degrees F for cold-climate and engine-bay environments
• 1/2-inch push-to-connect on both ends - no thread preparation or sealant required
• Lightweight composite body at 0.045 pounds

Compatibility

Designed as a D.O.T.-compliant push-to-connect union elbow for 1/2-inch OD tubing in pneumatic and air brake plumbing systems.

Installation Notes

Installation is typically performed by licensed plumbers, HVAC technicians, or qualified fleet maintenance technicians. Before servicing any pressurized line, depressurize the system completely and verify pressure has bled to zero. Ensure tubing ends are cut cleanly and squarely with no burrs before inserting into the push-to-connect ports. Follow applicable DOT regulations and local mechanical codes when installing in air brake or vehicle pneumatic systems.