Midland Industries 64507 Reducer Hex Bushing 3/4 X 1/4 in

Product Description

The MIDLAND INDUSTRIES 64507 is a galvanized malleable iron reducer hex bushing designed to transition between pipe sizes in threaded piping systems. It features a 3/4-inch male pipe thread (MPT) on the larger end and a 1/4-inch female pipe thread (FPT) on the smaller end, allowing a step-down connection within a single compact fitting. Rated at 150 psi and conforming to ANSI B16.3 dimensional standards, this bushing is suited for gas, water, and general industrial piping applications. The galvanized finish provides corrosion resistance in exposed or moderately harsh environments. Licensed plumbers and pipefitters are the typical installers.

This reducer hex bushing is used in residential and light commercial piping systems where a threaded line must reduce from 3/4 inch to 1/4 inch. Common install scenarios include supply line branch reductions, instrument port connections, and gauge tap connections in water, air, or gas distribution systems. It fits into standard 150-pound galvanized malleable iron fitting assemblies and is compatible with NPT-threaded pipe and fittings of corresponding sizes.

Key Features

• 3/4 in MPT x 1/4 in FPT reducer configuration for step-down thread transitions
• Galvanized malleable iron construction for corrosion resistance and durability
• 150 psi pressure rating suitable for typical low-pressure piping service
• Conforms to ANSI B16.3 dimensional standards
• Operating temperature range of -20 to 350 degrees F
• Hex body design allows wrench engagement for secure installation

Compatibility

Designed as an OEM-style replacement fitting for standard 150-pound galvanized malleable iron threaded piping systems using 3/4 in and 1/4 in NPT connections.

Installation Notes

Installation should be performed by a licensed plumber or pipefitter in accordance with applicable plumbing and mechanical codes, including the IPC and IFGC where relevant. Depressurize and isolate the piping system fully before removing or installing any threaded fittings. Apply an appropriate thread sealant or PTFE tape to male threads before assembly. Do not over-tighten, as malleable iron fittings can crack under excessive torque.