Midland Industries 64110 90 Degree Elbow 3 in Fpt Galvanized

Product Description

The MIDLAND INDUSTRIES 64110 is a 90-degree malleable iron elbow designed for galvanized pipe systems operating at pressures up to 150 lb class. Both end connections are 3-inch female pipe thread (FPT), conforming to ANSI B 16.3 dimensional standards. The galvanized finish provides corrosion resistance for use in wet or exposed environments. Rated for a temperature range of -20 degrees F to 350 degrees F, this fitting is suited for steam, water, air, and gas piping applications. Licensed plumbers and pipefitters install this type of fitting in commercial and industrial mechanical systems where a square directional change is required in a threaded iron piping run.

This elbow is used in galvanized 150-pound malleable iron piping systems across a range of applications including water distribution, compressed air, and low-pressure steam. The 3-inch FPT x 3-inch FPT configuration is common in larger-diameter runs found in commercial plumbing, HVAC hydronic systems, and light industrial installations. With a center-to-end dimension of 3.08 inches, it fits standard layout spacing for 3-inch threaded pipe assemblies.

Key Features

• 90-degree directional change with 3-inch FPT x 3-inch FPT connections on both ends
• Malleable iron construction with galvanized finish for corrosion resistance
• 150 lb pressure class rating per ANSI B 16.3
• Temperature range: -20 degrees F to 350 degrees F
• Center-to-end dimension of 3.08 inches for standard layout compatibility
• 3-8 thread specification for proper pipe thread engagement

Compatibility

Designed as an OEM-style fitting for galvanized 150-pound malleable iron threaded piping systems using 3-inch female pipe thread connections conforming to ANSI B 16.3 standards.

Installation Notes

Installation should be performed by a licensed plumber or pipefitter in accordance with applicable IPC or IFGC codes. Depressurize and isolate the piping system completely before removing or installing any threaded fittings. Apply an approved pipe thread sealant or PTFE tape to male threads before assembly. Do not over-tighten, as malleable iron fittings can crack under excessive torque.