Midland Industries 56162 Galvanized Steel Pipe Nipple Sch 40

Product Description

The MIDLAND INDUSTRIES 56162 is a Schedule 40 galvanized steel welded pipe nipple with male pipe thread (MPT) connections on both ends. At 3 inches in length with a 2-inch nominal diameter, it provides a short, rigid threaded extension for joining pipes, fittings, or valves in plumbing and industrial piping systems. The galvanized steel construction resists corrosion in wet or mildly corrosive environments. Rated to 2,500 psi with a temperature range of -150 to 200 degrees F, this nipple is built for demanding service. Wall thickness is 0.154 inches, and thread length is 1.06 inches per end, conforming to ANSI B1.20.1 dimensional standards.

This nipple is suited for residential and light commercial plumbing, gas distribution piping, and industrial pipe assemblies where a close or short threaded connection is needed. It installs in water supply lines, compressed air systems, and gas lines where galvanized steel and Schedule 40 pressure ratings are specified. Plumbers, pipefitters, and mechanical contractors commonly use this type of fitting when building or extending threaded pipe runs.

Key Features

• 2-inch MPT x 2-inch MPT configuration for standard threaded pipe connections
• Schedule 40 wall thickness of 0.154 inches for rated 2,500 psi service
• Galvanized steel construction for corrosion resistance in wet environments
• ANSI B1.20.1 thread dimensional standard for consistent fit across compatible fittings
• Operating temperature range of -150 to 200 degrees F
• Thread length of 1.06 inches per end for secure engagement

Compatibility

Designed as an OEM-style replacement and standard fitment for Schedule 40 galvanized steel threaded pipe systems using 2-inch nominal pipe size components.

Installation Notes

Installation is performed by licensed plumbers or pipefitters following applicable IPC or IFGC code requirements for the intended service. De-pressurize and shut off the supply line completely before removing or installing any threaded pipe fitting. Apply thread sealant or PTFE tape to the male threads before assembly to ensure a leak-free connection. Do not over-tighten threaded connections, as this can damage the fitting or mating threads.