Midland Industries 40032 Brass Pipe Nipple 1/4 Mpt 8 in

Product Description

The MIDLAND INDUSTRIES 40032 is a seamless lead-free red brass pipe nipple with 1/4 in male pipe thread (MPT) connections on both ends and an overall length of 8 inches. Constructed from Schedule 40 brass with a 0.082 in wall thickness, it carries a pressure rating of 125 lb class and a maximum working pressure of 870 psi at 100 degrees F. The 1/4-18 thread pattern conforms to ANSI B1.20.1, WW-N-351, and MS 51846 dimensional standards. Plumbers and pipefitters install this nipple in low- and high-pressure service lines where a corrosion-resistant, lead-free fitting is required.

This nipple is suited for residential and light commercial plumbing, gas distribution, and hydronic systems where a close or extension nipple between two female-threaded fittings, valves, or equipment ports is needed. The 8 in length makes it practical for installations requiring a longer standoff or offset between threaded components. Its lead-free red brass composition meets common potable water and fuel gas service requirements. The broad temperature range of -20 to 400 degrees F covers chilled water, hot water, and low-pressure steam applications.

Key Features

• Lead-free red brass construction meets potable water and fuel gas service standards
• Schedule 40 wall thickness of 0.082 inches for reliable pressure containment
• 870 psi maximum working pressure at 100 degrees F with a 125 lb pressure class rating
• Temperature range of -20 to 400 degrees F covers steam, hot water, and refrigeration service
• Conforms to ANSI B1.20.1, WW-N-351, and MS 51846 dimensional standards
• Seamless construction eliminates weld seams that can be potential failure points in high-cycle service

Compatibility

Designed as an OEM-style replacement or new-installation fitting for 1/4 in female NPT threaded ports in plumbing, HVAC, and gas distribution assemblies.

Installation Notes

Installation is performed by licensed plumbers or pipefitters following applicable IPC and IFGC code requirements. Apply thread sealant or PTFE tape rated for the intended service medium before threading into female ports. Hand-tighten first, then wrench-tighten using a pipe wrench or strap wrench - do not over-torque brass threads. Always depressurize and isolate the line before removing or installing threaded fittings.