Midland Industries 32444 Rigid Female Adapter Brass

Product Description

The MIDLAND INDUSTRIES 32444 is a rigid female adapter fitting designed to connect a 5/8-inch hose barb end to a 3/8-inch female NPTF threaded port. Machined from brass, this adapter provides a durable, corrosion-resistant connection point in fluid transfer lines. The 3/4-inch hex body allows for wrench installation without slipping. At 1.66 inches in length, it fits into tight plumbing assemblies. Rated for up to 150 psi operating pressure and a temperature range of -40 to 160 degrees F, this fitting handles a wide range of liquid and low-pressure fluid applications. Plumbers, HVAC technicians, and mechanical contractors use this type of adapter to terminate flexible hose runs at threaded female ports.

This fitting is suited for residential and light commercial plumbing, HVAC equipment connections, and general fluid transfer systems where a hose barb-to-female NPTF transition is required. It is compatible for use with hose clamps, similar-type clamps, or a crimped ferrule to secure the hose end. The NPTF thread form provides a pressure-tight mechanical seal without relying solely on sealant tape, making it a dependable choice for pressurized lines within its rated limits.

Key Features

• 5/8-inch hose barb inlet connects directly to flexible hose secured by clamp or crimped ferrule
• 3/8-inch female NPTF outlet creates a pressure-tight threaded connection
• Brass construction resists corrosion in water, air, and many common fluid media
• 3/4-inch hex body enables secure wrench tightening during installation
• Rated to 150 psi maximum operating pressure
• Wide temperature range of -40 to 160 degrees F suits most indoor and mechanical-room environments

Compatibility

Designed for use with hose clamps, similar-type clamps, or crimped ferrules on 5/8-inch flexible hose terminating at a 3/8-inch female NPTF threaded port. Suitable for low-pressure fluid transfer applications within the rated pressure and temperature limits.

Installation Notes

Installation is typically performed by a licensed plumber or HVAC technician following applicable IPC or mechanical code requirements. Shut off the fluid supply and relieve system pressure before threading or unthreading any fitting. Apply thread sealant or PTFE tape to the male threads mating into this fitting as required by the application, even though NPTF threads are designed to seal on the thread form. Secure the hose barb end with an appropriately rated clamp or crimped ferrule before returning the system to service.