Midland Industries 32100 Brass Flare Swivel Adapter 1/2 in

Product Description

The MIDLAND INDUSTRIES 32100 is a brass SAE 45-degree flare swivel adapter designed to connect a 1/2-inch hose barb end to a 1/2-inch 45-degree flared female port. The swivel function on the flared end allows the fitting to rotate freely during tightening, reducing torque transfer to the hose and minimizing the risk of hose twist or stress. Built from brass, this adapter offers reliable corrosion resistance for fluid and gas transfer applications. It carries a maximum operating pressure rating of 150 psi and features a 3/4-16 thread with a 0.87-inch hex for standard wrench engagement. Licensed plumbers, HVAC technicians, and mechanical contractors are the typical installers.

This adapter is suited for residential and light commercial applications where a hose assembly must terminate at an SAE 45-degree flared female connection. Common scenarios include refrigeration line sets, fuel delivery systems, and hydraulic or pneumatic hose assemblies requiring a secure, leak-resistant transition between a barbed hose end and a flared port. It is compatible for use with hose clamps, similar-type clamps, or crimped ferrules, making it adaptable to various hose termination methods already in use on the job.

Key Features

• Swivel flare end rotates freely to prevent hose twist during installation
• SAE 45-degree flared female connection on one end, 1/2-inch hose barb on the other
• Brass construction provides corrosion resistance for fluid and gas service
• Rated to 150 psi maximum operating pressure
• 3/4-16 thread with 0.87-inch hex for standard wrench access
• Compatible with hose clamps, similar-type clamps, or crimped ferrules

Compatibility

Designed for use with hose assemblies secured by hose clamps, similar-type clamps, or crimped ferrules where an SAE 45-degree flared female port is required at the mating connection.

Installation Notes

Installation is typically performed by a licensed plumber, HVAC technician, or mechanical contractor. Shut off all system pressure and relieve any residual line pressure before disassembling existing fittings or installing this adapter. Use an appropriately sized wrench on the hex flats and do not over-tighten, as brass fittings can deform under excessive force. Ensure the mating flared surface is clean, undamaged, and properly formed to the SAE 45-degree specification before making up the connection.