Midland Industries 32082 45-deg Sae Flare Male Adapter Brass

Product Description

The MIDLAND INDUSTRIES 32082 is a 45-degree SAE flare male adapter designed to connect a 1/4-inch hose barb on one end to a 3/8-inch male flared fitting on the other. Constructed from brass, this adapter is rated for a maximum operating pressure of 150 psi and performs across a temperature range of -40 to 160 degrees F. The 5/8-18 thread and 0.62-inch hex wrench flat make installation straightforward in tight spaces. At 1.82 inches in length and 0.06 pounds, it is a compact, lightweight fitting suited for refrigeration, HVAC, and fluid-handling line connections.

This adapter is used in residential and light commercial HVAC, refrigeration, and plumbing applications where a hose assembly must transition to a 45-degree SAE flare male port. The hose barb end is compatible with hose clamp, similar-style clamp, or crimped ferrule retention methods, giving installers flexibility depending on the hose assembly type on hand. Typical install scenarios include connecting flexible hose to a flared port on a valve, manifold, or equipment fitting.

Key Features

• 45-degree SAE flare male connection on one end for secure, leak-resistant seating
• 1/4-inch hose barb end accepts hose clamp, similar clamp, or crimped ferrule attachment
• Brass construction provides corrosion resistance for fluid and refrigerant service
• 150 psi maximum operating pressure suitable for low-pressure HVAC and fluid lines
• Wide service temperature range of -40 to 160 degrees F
• Compact 1.82-inch length with 0.62-inch hex for wrench access in confined spaces

Compatibility

Designed for use with hose assemblies retained by hose clamps, similar-type clamps, or crimped ferrules connecting to 3/8-inch male SAE flare ports in HVAC, refrigeration, and fluid-handling systems.

Installation Notes

Installation should be performed by a qualified HVAC technician or plumber. Depressurize and isolate the line before disassembly or fitting installation. Use an appropriately sized wrench on the 0.62-inch hex flat to avoid rounding; do not over-tighten the flare connection, as brass fittings are susceptible to thread damage from excessive torque beyond hand-tight plus a controlled turn. Ensure the hose is fully seated on the barb before applying the clamp or ferrule crimp.