Midland Industries 10262L Sae 45-deg Flare Adapter Brass

Product Description

The MIDLAND INDUSTRIES 10262L is a male SAE 45-degree flare adapter designed to connect 3/8-inch male flared tubing to a 1/8-inch male NPTF port. Thread dimensions are 5/8-18 on the flare end and 1/8-27 on the NPTF end. Machined from brass, this fitting provides reliable sealing across a working pressure rating of 1000 psi and an operating temperature range of -65 to 250 degrees F. Plumbers, HVAC technicians, and hydraulic system installers use this adapter to transition between flared tubing lines and threaded pipe ports in tight-tolerance fluid systems.

This adapter is suited for residential and light commercial applications where copper, brass, aluminum, or steel hydraulic tubing must terminate at an NPT-threaded port. Typical install scenarios include refrigeration line sets, hydraulic control circuits, and fuel or oil delivery systems. Its compact profile - measuring approximately 1.1 inches in length and 0.65 inches in width - allows installation in confined equipment spaces without requiring additional clearance for bulky fittings.

Key Features

• SAE 45-degree flare geometry for leak-free tubing connections
• 1000 psi working pressure rating for hydraulic and refrigeration service
• Operating temperature range of -65 to 250 degrees F
• 5/8-18 male flare thread mates to 3/8-inch OD tubing flares
• 1/8-27 NPTF thread provides pressure-tight seal without sealant tape in many applications
• Brass construction resists corrosion in wet and fluid-handling environments

Compatibility

Designed for use with copper, brass, aluminum, and steel hydraulic tubing. Compatible with any system using a 3/8-inch SAE 45-degree male flare inlet and a 1/8-inch NPTF female port.

Installation Notes

Installation is typically performed by licensed plumbers, HVAC technicians, or hydraulic system technicians. Always depressurize and evacuate the line before removing or installing any fitting. Hand-tighten the flare connection first to confirm thread engagement, then wrench-tighten to avoid cross-threading or over-torquing the brass body. NPTF threads are designed to seal on thread interference, but consult system specifications to determine whether thread sealant is required for your application.