Merit Brass 2004-150BSPT Brass Pipe Nipple 1/4 in Bspt

Product Description

The MERIT BRASS 2004-150BSPT is a short red brass pipe nipple threaded on both ends to the BSPT (British Standard Pipe Taper) standard. At 1.5 inches overall length with a 1/4 inch outside diameter, this close nipple is machined from red brass for corrosion resistance and reliable sealing in low-pressure fluid and gas piping assemblies. It is used to create a direct threaded connection between two female-threaded fittings. Licensed plumbers, pipefitters, and HVAC technicians install these as part of domestic water, compressed air, and instrumentation piping systems where BSPT threading is specified.

This nipple is suited for residential and light commercial plumbing and HVAC applications where a compact, rigid connection is required between two fittings. The BSPT thread form is common in imported equipment, process instrumentation, and international-spec systems. At 1/4 inch IPS sizing, it fits into tight-clearance runs where standard close nipples are practical. This part meets OSHA standards, making it appropriate for workplace and commercial installations where compliance documentation may be required.

Key Features

• Red brass construction resists corrosion in water and fluid service
• Threaded on both ends for direct fitting-to-fitting connections
• BSPT thread standard for compatibility with international and imported equipment
• 1.5 inch overall length in a compact close-nipple profile
• Meets OSHA standards for workplace and commercial piping installations
• 1/4 inch IPS sizing fits standard small-diameter piping assemblies

Compatibility

Designed as an OEM-style replacement or new-installation component for 1/4 inch BSPT female-threaded fittings in plumbing, HVAC, and instrumentation piping systems.

Installation Notes

Installation is performed by licensed plumbers or pipefitters following applicable IPC and local plumbing code requirements. Shut off and depressurize the piping system fully before removing or installing any threaded nipple. Apply an appropriate thread sealant or PTFE tape rated for the service fluid before making up the joint. Do not over-tighten, as red brass threads can be damaged by excessive torque.