Merit Brass 2002-300BSPT Brass Pipe Nipple 1/8 in Bspt

Product Description

The MERIT BRASS 2002-300BSPT is a red brass pipe nipple threaded on both ends to a 1/8 inch BSPT standard. At 3 inches overall length with a 1/8 inch outside diameter, this nipple is used to connect or extend threaded pipe runs in tight-quarter applications. Red brass construction provides reliable corrosion resistance in water, steam, and light gas service. Plumbers, pipefitters, and mechanical contractors install this fitting in systems where BSPT thread form is required. The OSHA-compliant designation confirms it meets recognized safety standards for industrial and commercial use.

This nipple is suited for residential and commercial plumbing, HVAC hydronic systems, compressed air lines, and instrumentation tie-ins where a short, fully threaded brass nipple is needed. The 1/8 inch IPS-equivalent size makes it a common choice for gauge ports, bleed connections, and low-flow branch lines. Its compact 3 inch length fits standard close-nipple applications where a hex nipple would be too short but a longer nipple is unnecessary.

Key Features

• Threaded on both ends for direct pipe-to-pipe or pipe-to-fitting connections
• BSPT thread standard for compatibility with British Standard Parallel and Taper Pipe Thread fittings
• Red brass material offers strong corrosion resistance in water, steam, and mild chemical service
• OSHA-compliant construction meets recognized workplace safety standards
• 3 inch overall length suits close-quarter and instrument-port installations

Compatibility

Designed as an OEM-style replacement or standard-service fitting for piping systems requiring 1/8 inch BSPT threaded nipples in brass.

Installation Notes

Installation is performed by licensed plumbers or pipefitters following applicable IPC and IFGC codes for the service medium. Shut off and depressurize the line before removing or installing any threaded fitting. Apply an appropriate thread sealant or PTFE tape rated for the service medium to the male threads before assembly. Do not over-torque brass fittings, as the material is softer than iron or steel and susceptible to thread damage.