Mcr Safety PD6901S Mechanics Gloves Ansi A9 Small

Product Description

The MCR SAFETY PD6901S is a mechanics-style work glove built for high-risk cut, puncture, and abrasion environments. The glove uses a MAXGrid palm coating over a HyperMax lining to deliver ANSI/ISEA Cut Resistance Level A9 and Puncture Resistance Level 3 in a single unit. TPR back material adds impact protection without sacrificing dexterity. At 11 inches in overall length and sized for small hands, this unisex glove fits a range of trades workers. A hook-and-loop cuff provides a secure, adjustable fit during active use. HVAC technicians, electricians, plumbers, and industrial maintenance professionals rely on this class of glove when working around sheet metal, wire, glass, and other sharp materials.

The PD6901S is designed for trades and industrial applications where contact with sharp edges, puncture hazards, and abrasive surfaces is routine. Typical install and service scenarios include handling sheet metal ductwork, pulling wire through conduit, working with glass or insulation, and general mechanical assembly. The palm-only MAXGrid coating preserves tactile feedback on the back of the hand while reinforcing the contact surface most exposed to cuts and abrasion. The black and lime colorway improves visibility on the job site. This glove ships as a single pair and is suited for individual issuance or as a stocked replacement glove in a shop or service vehicle.

Key Features

• ANSI/ISEA Cut Resistance Level A9 for protection against severe cut hazards
• ANSI/ISEA Puncture Resistance Level 3 for resistance against sharp point penetration
• ANSI/ISEA Abrasion Resistance Level 4 for durability against abrasive surfaces
• MAXGrid palm coating provides grip and cut protection on the highest-contact surface
• HyperMax lining delivers cut resistance with maintained glove flexibility
• TPR back material offers impact and abrasion protection on the dorsal side
• Hook-and-loop cuff for an adjustable, secure fit during work

Compatibility

Designed as an OEM-style mechanics work glove for small-handed users in trades and industrial applications requiring ANSI/ISEA A9 cut resistance.

Installation Notes

Inspect gloves before each use for cuts, abrasion wear-through, or coating separation. Replace immediately if the MAXGrid palm coating shows visible degradation, as cut resistance performance depends on coating integrity. These gloves are not rated as electrical insulating PPE and should not be used as a substitute for voltage-rated gloves when working on energized equipment. Follow your employer safety program and applicable OSHA PPE requirements for glove selection and replacement intervals.