Macomb Group Approved T202AA300X100 Water Suction Hose

Product Description

The MACOMB GROUP APPROVED T202AA300X100 is an EPDM rubber water suction hose built for general-purpose liquid transfer in demanding field conditions. With a 3-inch inside diameter and 150 PSI maximum working pressure, this hose moves high volumes of water efficiently on construction sites, agricultural operations, and industrial pump setups. The EPDM construction handles a wide temperature range from -22 degrees F to 176 degrees F, making it serviceable in both cold-weather dewatering and warm-climate irrigation applications. The 100-foot length and 12-inch minimum bend radius suit it for pump inlets where long runs and moderate routing flexibility are required. Plumbers, contractors, and water-management crews rely on this type of hose for reliable suction-side performance.

This hose is designed for water suction and discharge service in residential, commercial, and light industrial environments. Typical applications include portable pump intake lines, dewatering operations, farm irrigation, tank filling, and municipal service work. The 3-inch bore accommodates high-flow centrifugal and diaphragm pump configurations. At 100 feet, a single length covers most jobsite runs without requiring couplers at intermediate points. The black EPDM tube and cover resist weathering, ozone, and UV exposure for outdoor storage and extended field use.

Key Features

• 3-inch inside diameter supports high-volume water transfer with compatible pump fittings
• 150 PSI maximum working pressure rated for demanding suction and low-pressure discharge service
• EPDM rubber construction resists ozone, UV, and weathering for outdoor and all-season use
• Temperature range of -22 degrees F to 176 degrees F covers cold-weather dewatering and warm-climate irrigation
• 12-inch minimum bend radius allows routing around obstacles without kinking or flow restriction
• 100-foot continuous length reduces the need for mid-run couplings and potential leak points

Compatibility

Designed as a general-purpose replacement or new-installation suction hose for standard 3-inch pump inlet and outlet fittings used in water transfer, dewatering, and irrigation systems.

Installation Notes

Installation is typically performed by plumbers, pump mechanics, or irrigation contractors familiar with suction-side hose connections. Ensure the pump is fully shut down and depressurized before disconnecting or connecting hose ends. Use properly rated clamps or cam-lock fittings rated for the full 150 PSI working pressure, and inspect both end connections for debris or damage before pressurizing. Do not exceed the minimum bend radius of 12 inches during routing, as sharp bends restrict flow and accelerate hose wear.