Lynn Electronics GGAA306DP220FA Lc Lc OM3 Fiber Cable 6F 220ft

Product Description

The LYNN ELECTRONICS GGAA306DP220FA is a multimode OM3 fiber optic patch cable terminated with LC connectors on both ends. Rated for 10 Gigabit Ethernet applications, this cable carries a 6-fiber count and spans 220 feet, making it well suited for longer structured cabling runs within data centers, server rooms, and enterprise network closets. The OM3 fiber grade supports 10GbE transmission at this distance without signal degradation under standard deployment conditions. Installation is handled by network technicians, data center cabling crews, or licensed low-voltage contractors.

This patch cable is designed for horizontal or backbone fiber runs in environments where 10GbE performance is required over extended distances. The duplex LC connector format is widely used in active equipment such as switches, routers, media converters, and SFP+ transceivers. The 6-fiber construction allows multiple independent links to be routed through a single cable jacket, reducing conduit fill and simplifying cable management in high-density installations.

Key Features

• OM3-rated multimode fiber supports 10 Gigabit Ethernet transmission
• LC to LC connector configuration compatible with standard SFP+ ports
• 6-fiber count enables multiple simultaneous links in one cable run
• 220-foot length accommodates longer intra-building or inter-rack runs
• Duplex LC format simplifies connection to common active networking hardware

Compatibility

Designed as an OEM-style replacement or new-installation fiber patch cable for 10GbE multimode fiber infrastructure using LC duplex terminations.

Installation Notes

Installation should be performed by a qualified low-voltage or network cabling technician in accordance with applicable structured cabling standards such as ANSI/TIA-568. Power down or disable active ports on connected equipment before seating or removing LC connectors to avoid optical damage or link errors. Avoid sharp bends below the cable minimum bend radius, and do not exceed the rated tensile load during pulling. Keep connector end-faces capped or cleaned before termination.