Lynn Electronics ECAT5-4PR-03-ORB Cat5e Patch Cable 3ft

Product Description

The LYNN ELECTRONICS ECAT5-4PR-03-ORB is a Cat5e booted patch cable designed for structured cabling and network data runs in commercial and residential low-voltage installations. At 3 feet in length, this cable is well suited for short equipment-to-patch-panel runs, rack-to-switch connections, and tight-space data closet work. The molded boot protects the RJ45 latch from snag damage and strain during repeated plug-and-unplug service cycles. Cat5e construction supports up to 1 Gbps Ethernet and 100 MHz bandwidth, making it a standard choice for network drops, patch bays, and structured wiring panels. The orange jacket provides quick visual identification by segment or zone in high-density cable environments. Low-voltage technicians and network installers are the primary trade for this cable.

This patch cable is used in light commercial and residential network installations wherever a short, pre-terminated Cat5e run is needed. Typical applications include switch-to-server connections, patch panel port terminations, VoIP equipment hookups, and PoE device connections. The 3-foot length is a common fit for equipment rack environments where cable management and minimal slack are priorities. The booted RJ45 connectors on each end are pre-installed, eliminating field termination time.

Key Features

• Cat5e construction supports 1 Gbps Ethernet and 100 MHz bandwidth
• 3-foot length suits short rack and patch panel runs
• Orange jacket enables quick visual zone identification in dense cable environments
• Molded boot protects RJ45 latch from snag damage and extends connector lifespan
• Pre-terminated ends eliminate field crimping and reduce installation time
• Sold individually, one cable per unit

Compatibility

Designed as a standard Cat5e patch cable for use with RJ45-equipped switches, routers, patch panels, and network interface equipment in residential and light commercial structured cabling systems.

Installation Notes

Installation is performed by low-voltage technicians or network cabling professionals. De-energize PoE switches or injectors before connecting or disconnecting cables to PoE-powered devices when possible. Avoid sharp bends below the minimum bend radius of Cat5e cable to prevent signal degradation. Route and secure cables per TIA-568 structured cabling standards for compliant installations.