Lutron Electronics RRD-W6BRL-SW Radiora 2 Wall Keypad

Product Description

The LUTRON ELECTRONICS RRD-W6BRL-SW is a 6-button wall keypad designed for use with the RadioRA 2 whole-home lighting control system. It provides a wall-mounted interface for controlling multiple lighting scenes or zones from a single location. Electricians and low-voltage control technicians install this keypad as part of a structured RadioRA 2 network, where it communicates with the system processor to trigger programmed lighting scenes. The Snow finish allows the keypad to blend with standard white trim and decor. This unit ships as a single piece and falls within the dimmers and switches product category.

The RRD-W6BRL-SW is suited for residential and light commercial installations where multiple lighting zones require scene-based control from a centralized wall location. It is intended for use within a properly configured RadioRA 2 system, which requires a compatible main repeater and system programming. Typical installations include living rooms, conference rooms, hallways, and other spaces where scene selection from a wall station is preferred over individual dimmer control.

Key Features

• 6 buttons provide dedicated scene or zone control from a single wall station
• Designed for the RadioRA 2 lighting control platform
• Snow finish coordinates with standard white electrical trim
• Wall-mounted form factor replaces standard single-gang locations
• Sold as an individual unit for flexible system expansion

Compatibility

Designed for use within a RadioRA 2 lighting control system. Requires a compatible RadioRA 2 main repeater and system configuration software for full operation.

Installation Notes

Installation should be performed by a licensed electrician or certified low-voltage systems technician familiar with RadioRA 2 system architecture. Power to the circuit should be shut off at the breaker before any wiring connections are made. Device programming and scene assignment are completed through the RadioRA 2 setup software after physical installation. Follow all applicable NEC requirements for low-voltage control wiring and device installation.