Leviton Telcom L8564-100 Pull Grip Double Weave Long

Product Description

The LEVITON TELCOM L8564-100 is a single-entry, double-weave pull grip designed for pulling and supporting cables during installation. This type of pull grip uses a woven mesh sleeve that tightens around the cable as tension is applied, distributing load evenly and reducing the risk of jacket damage. It is sized for cables with an outer diameter ranging from 1 to 1.5 inches and features a long-body design that provides additional grip length for heavier or longer cable runs. Electricians and low-voltage installers use this hardware accessory in conduit pulls, cable tray work, and overhead suspension applications.

This pull grip is suited for commercial and residential low-voltage and electrical installations where cables in the 1 to 1.5 inch diameter range need to be pulled through conduit or suspended from messenger wire. The double-weave construction offers increased strength compared to single-weave designs, making it appropriate for longer runs or situations where sustained tension is expected. It is sold as a single unit and is a standard hardware accessory used by electricians and communications installers.

Key Features

• Single-entry design accepts cables from 1 to 1.5 inches in outer diameter
• Double-weave mesh construction distributes pull load evenly across the cable jacket
• Long-body design increases grip surface area for demanding pulls
• Tightens under tension for secure hold without additional fasteners
• Sold individually as a single unit

Compatibility

Designed as a standard hardware accessory pull grip for cables with an outer diameter of 1 to 1.5 inches, suitable for typical conduit pull and cable suspension applications in that size range.

Installation Notes

Pull grips of this type are installed by licensed electricians or low-voltage technicians following applicable NEC guidelines. De-energize all circuits in the work area before beginning a cable pull. Slide the mesh sleeve over the cable end and secure it before attaching to a pull line or swivel. Avoid exceeding the rated tension for the grip or the minimum bend radius of the cable being pulled.