Leviton Telcom L7782 Strain Relief Grip Half Wave

Product Description

The LEVITON TELCOM L7782 is a half-wave strain relief grip designed to secure and protect cables and conductors at entry points into enclosures, junction boxes, and electrical panels. It accommodates cable diameters from 0.875 inches to 1.000 inches, providing a firm, consistent grip that reduces mechanical stress on conductors and terminations. Electricians and low-voltage installers use this type of fitting to maintain cable integrity at transition points where movement, vibration, or pull forces could otherwise damage insulation or loosen connections. Sold individually, this is a hardware accessory category component intended for use in both new installation and retrofit work.

The L7782 is suited for applications where a half-wave grip profile is required to fit constrained entry points or where cable bundle diameter falls in the 0.875 to 1.000 inch range. Common installation scenarios include control panels, communication enclosures, and electrical boxes where cable management and strain relief are required by code or good practice. The half-wave design allows installation in tighter spaces compared to full-wave alternatives, making it a practical choice for retrofit panel work where clearance is limited.

Key Features

• Accommodates cable diameters from 0.875 inches to 1.000 inches
• Half-wave grip profile for use in space-constrained enclosures
• Reduces mechanical stress on conductors and terminations at entry points
• Sold individually for single-point repair or replacement installs
• Hardware accessory classification suitable for panel and enclosure work

Compatibility

Designed as a standard strain relief grip for electrical enclosures, junction boxes, and communication panels where cable entry diameters fall between 0.875 and 1.000 inches and a half-wave grip profile is specified.

Installation Notes

Installation is typically performed by a licensed electrician or low-voltage technician. De-energize the panel or enclosure completely before beginning any cable entry work. Ensure the mounting hole diameter matches the grip body before seating the fitting to avoid improper sealing or grip failure. Follow NEC requirements for strain relief and cable support as applicable to the installation type.