Leviton Telcom HUB-200 Watertight Conduit Hub 2 in

Product Description

The LEVITON TELCOM HUB-200 is a watertight conduit hub designed for 2-inch conduit terminations. It provides a secure, moisture-resistant seal where conduit enters enclosures, panels, or junction boxes. This type of fitting is a standard component in electrical distribution and low-voltage wiring installations where conduit penetrations must be protected against water ingress. Licensed electricians and electrical contractors install this fitting as part of conduit system assemblies in both indoor and outdoor applications where moisture protection is required.

The HUB-200 is suited for use in residential, commercial, and light industrial electrical installations. It is typically installed at the point where a 2-inch conduit run terminates at a panel, pull box, or enclosure. Applications include service entrance conduit terminations, outdoor enclosure entries, and any conduit run routed through areas exposed to moisture or weather. It is sold individually as a single unit.

Key Features

• Watertight design provides moisture-resistant seal at conduit entry points
• Sized for 2-inch conduit terminations
• Single-unit packaging for targeted replacement or new installation use
• Hardware accessory category fitting for conduit system assemblies

Compatibility

Designed as an OEM-style replacement or standard new-installation fitting for 2-inch conduit systems requiring watertight termination at enclosures or panels.

Installation Notes

Installation is performed by a licensed electrician following applicable NEC guidelines for conduit terminations and weatherproof fittings. De-energize all circuits and verify power is off before working inside any panel or enclosure. Hand-tighten the hub onto the conduit and enclosure knockout, then use the appropriate spanner or strap wrench to achieve a secure, watertight connection without over-torquing the fitting. Ensure the conduit is properly supported and aligned before final tightening.