Leviton AGTR2-E Gfci Receptacle 20A 5-20R Commercial

Product Description

The LEVITON AGTR2-E is a commercial-grade GFCI receptacle rated for 20-amp circuits with a NEMA 5-20R configuration. It provides ground-fault circuit interrupter protection by detecting current imbalances between the hot and neutral conductors and tripping the circuit when a fault is detected. The manual reset type requires a deliberate reset action, confirming the fault condition has been cleared before power is restored. This receptacle is a single-phase, 2-pole, 3-wire device suited for installation by licensed electricians in commercial and light-industrial applications where GFCI protection is required by code.

The AGTR2-E is designed for commercial environments where 20-amp GFCI protection is required under NEC Article 210.8. Typical install locations include commercial kitchens, restrooms, locker rooms, garages, outdoor receptacle locations, and other areas where water or moisture exposure creates a shock hazard. Back-wire and side-wire termination options allow flexibility during rough-in and trim-out. Single-phase, 120-volt branch circuits feeding 20-amp loads are the standard application.

Key Features

• NEMA 5-20R configuration accepts both 15-amp and 20-amp plug types
• Manual reset confirms fault clearance before restoring power
• Back-wire and side-wire termination options for installation flexibility
• Commercial grade construction for higher-duty applications
• CSA Certified to applicable safety standards
• Single-phase, 2-pole, 3-wire circuit configuration

Compatibility

Designed as a commercial-grade GFCI receptacle replacement or new-installation device for standard single-gang electrical boxes on 20-amp, 120-volt branch circuits.

Installation Notes

Installation must be performed by a licensed electrician in accordance with the National Electrical Code (NEC) and applicable local codes. Always de-energize the branch circuit at the panel and verify absence of voltage with a meter before connecting or removing any wiring. Back-wire and side-wire terminals are both available on this device — do not exceed the conductor fill or torque specifications listed on the device label. GFCI devices should be tested after installation using the built-in test and reset buttons to verify proper operation.