L H Dottie Co TBC363 Toggle Bolt 3/16 X 3 Inch 50 Pack

Product Description

The L H Dottie Co TBC363 is a slotted/Phillips combination-drive toggle bolt designed for fastening into hollow walls, ceilings, and other cavity-construction substrates. The dual-drive recess accepts both a flathead and a Phillips screwdriver, giving installers flexibility in the field. At 3/16 inch in diameter and 3 inches in length, this fastener is sized for medium-load anchoring applications. It ships in a 50-count pack, making it practical for contractors who need job-site quantities rather than single-piece hardware. Electricians, HVAC techs, and plumbers routinely use toggle bolts to mount conduit straps, bracket hardware, and equipment supports to drywall or plaster where stud or solid backing is not accessible.

The TBC363 is suited for residential and light commercial applications where hollow-wall anchoring is required. Common install scenarios include mounting electrical enclosures, junction boxes, straps, and light fixtures to drywall or plaster ceilings. The 50-piece pack quantity supports production-rate work on new construction or retrofit projects where multiple fastener points are needed across a single installation.

Key Features

• Slotted and Phillips combination drive accepts two common screwdriver types
• 3/16 inch diameter x 3 inch length for medium-load hollow-wall anchoring
• 50-count pack quantity supports job-site volume needs
• Toggle wing design spreads load across the backside of hollow wall or ceiling material
• Compatible with standard toggle bolt installation procedures requiring a pre-drilled clearance hole

Compatibility

Designed as a standard toggle bolt replacement or new-installation fastener for hollow drywall, plaster, and similar cavity-wall substrates common in residential and light commercial construction.

Installation Notes

Toggle bolts are installed by licensed electricians, HVAC technicians, plumbers, and general contractors working with hollow-wall substrates. Before installation, drill a clearance hole sized to allow the collapsed toggle wing to pass through. De-energize any circuits behind the work surface before drilling. Do not overtighten the screw, as excessive torque can pull the toggle through soft drywall or damage the fastener threads.