L H Dottie Co SA14214 Sleeve Anchor 1/4 X 2-1/4 Inch 100 Pack

Product Description

The L H Dottie Co SA14214 is a sleeve anchor designed for fastening into concrete, block, and masonry substrates. Each anchor uses an expansion sleeve mechanism that tightens against the base material as the bolt is torqued, creating a secure mechanical hold. Sized at 1/4 inch diameter and 2-1/4 inches in length, these anchors are well suited for light- to medium-duty anchoring tasks in structural and non-structural applications. This package contains 100 anchors, making it practical for jobs requiring repetitive fastening into hard base materials. Electricians, plumbers, HVAC installers, and general trade contractors commonly stock sleeve anchors for securing conduit hangers, pipe straps, equipment mounts, and brackets to concrete surfaces.

Sleeve anchors in this size range are used across residential and commercial jobsites wherever a threaded fastener must be set into a concrete slab, poured wall, concrete block, or similar masonry surface. The 1/4 inch diameter fits standard clearance holes and pairs with common hardware such as strut channel clips, pipe clamps, and electrical box supports. The 100-piece pack is sized for contractors who need a ready supply on multi-point installations or ongoing service work.

Key Features

• 1/4 inch diameter by 2-1/4 inch length sleeve anchor configuration
• Expansion sleeve design locks mechanically into concrete and masonry
• 100-piece pack reduces restocking interruptions on multi-anchor jobs
• Threaded bolt end accepts standard nuts and washers for surface clamping
• Suitable for securing conduit, pipe supports, equipment rails, and brackets

Compatibility

Designed as a standard 1/4 inch sleeve anchor for use in concrete, concrete block, and solid masonry base materials where a mechanically expanding anchor is required.

Installation Notes

Sleeve anchors are installed by licensed trades including electricians, plumbers, and HVAC mechanics in accordance with applicable codes such as the NEC or IPC where anchoring of trade systems is required. Drill the base material to the specified hole diameter and minimum embedment depth before inserting the anchor. Never install in cracked, spalled, or deteriorated concrete without engineering review. Verify minimum edge distance and spacing requirements for the substrate type before setting anchors.