L H Dottie Co SA14138 Sleeve Anchors 1/4x1-3/8 100-pack

Product Description

The L H Dottie Co SA14138 is a 100-piece pack of sleeve anchors sized at 1/4 inch diameter by 1-3/8 inch length. Sleeve anchors are expansion-style fasteners used to secure fixtures, equipment brackets, conduit hangers, pipe supports, and similar hardware to concrete, block, or masonry substrates. Each anchor expands as the nut is tightened, creating a secure mechanical hold in the base material. This pack is well-suited for trade work where multiple anchor points are required in a single job, reducing the need for multiple supply runs. Electricians, plumbers, and HVAC technicians commonly use sleeve anchors when anchoring equipment or supports to structural masonry.

The SA14138 sleeve anchors are appropriate for residential and light commercial applications where a 1/4 inch fastener meets the load and spacing requirements of the installation. Common use cases include mounting conduit straps, pipe hangers, junction box supports, and equipment pads to poured concrete or concrete masonry unit walls and floors. The 100-piece quantity is practical for production work or stocking a service vehicle.

Key Features

• 1/4 inch diameter by 1-3/8 inch length sleeve anchor configuration
• Expansion-style design locks into concrete, block, or masonry on tightening
• 100-piece pack supports high-volume or multi-point installations
• Suitable for anchoring pipe supports, conduit hangers, and equipment brackets
• Consistent sizing across all 100 pieces for uniform installation workflow

Compatibility

Designed as an OEM-style sleeve anchor for use in standard 1/4 inch diameter holes drilled into concrete, block, or masonry substrates.

Installation Notes

Sleeve anchors are installed by licensed electricians, plumbers, pipefitters, and HVAC technicians in accordance with applicable mechanical and electrical codes. Drill the base material to the correct diameter and minimum embedment depth before inserting the anchor. Use a torque wrench or impact driver set to an appropriate setting to avoid over-tightening, which can strip the anchor or crack the substrate. Always follow the fastener manufacturer guidelines and local code requirements for anchor spacing and edge distance.