Kurt DL640-KIT2 11 Piece Repair Kit DL640 Vise

Product Description

The KURT DL640-KIT2 is an 11-piece repair kit designed to rebuild and restore Kurt Series DL640 vises used in machine shop and industrial workholding applications. The kit consolidates the most commonly replaced internal components into a single package, reducing downtime when a DL640 vise requires service. Components include thrust bearing washers, wiper ring seals, a dowel pin, an O-ring, a pre-load spring, a retaining ring, a roll pin, a spring clutch, and a thrust bearing. Machinists and tool room technicians handling DL640 vise maintenance will find this kit covers the critical wear and sealing components in one order.

This kit is intended for use with the Kurt Series DL640 vise, specifically units carrying serial part numbers 3735 through 4999. It is suited for production machine shops, tool rooms, and industrial maintenance environments where DL640 vises are in active service. When a vise begins showing wear through reduced clamping precision, seal degradation, or bearing failure, this kit provides the replacement parts needed to return the unit to proper operating condition without sourcing components individually.

Key Features

• 11-piece kit covers primary wear and sealing components for DL640 vise rebuild
• Includes two thrust bearing washers and one thrust bearing for load-bearing surface restoration
• Two wiper ring seals included to protect internal components from contamination
• Pre-load spring and spring clutch address clamping mechanism wear
• Retaining ring, roll pin, and dowel pin round out the hardware essentials for a complete service
• Single-package kit minimizes sourcing time for DL640 vise maintenance

Compatibility

Designed for use with the Kurt Series DL640 vise, serial part numbers 3735 through 4999. Verify the serial number on the vise before ordering to confirm fitment.

Installation Notes

Installation should be performed by a qualified machinist or tool room technician familiar with Kurt vise disassembly procedures. Remove the vise from the machine and fully release any clamping load before beginning disassembly. Follow the Kurt DL640 service documentation for component removal and reassembly sequence to ensure correct orientation of the thrust bearing, spring clutch, and retaining ring. Clean all mating surfaces before installing new seals and bearing components.